-
Hello! I’m hoping for some opinions on which scanner(s) would fit the tall order I’m about to describe: I need …
- 113 views
- 1 answers
- 0 votes
-
Greetings, I am reading from *.dxf and I want to put the lines and arcs in order based on their …
- 249 views
- 1 answers
- 0 votes
-
When I sat my AutoCAD course many years ago, I was shown how to extend all lines as a single …
- 214 views
- 2 answers
- 0 votes
-
I tried many sites and all are asking to sign-up to view a .dwg file.
- 203 views
- 3 answers
- 0 votes
-
Hi, I created a model in AutoCAD Plant 3D 2021. I have Object Enablers Installed In my PC with the …
- 245 views
- 1 answers
- 0 votes
-
I have worked in the Engineering /Architectural/consulting industry using AutoCAD products. Are there other industries, or lines of work that …
- 216 views
- 2 answers
- 0 votes
-
Hi, Every time I open a new drawing, I get a warning message pop up. The message says “Start point of chosen …
- 199 views
- 1 answers
- 0 votes
-
Hi, I am creating 3D model in AutoCAD Plant 3D and I created RCC Tank (See Attached RCC Tank-1). But …
- 227 views
- 1 answers
- 0 votes
-
Good day, I have just been retrenched due to the COVID 19 pandemic, I have 12 years of experience as a …
- 344 views
- 3 answers
- 0 votes
-
How can I determine the plane angle for the small slot on the upper face when the pin is at …
- 209 views
- 1 answers
- 0 votes
All Questions
Filter by
Filter by
Questions Per Page:
